Mummy Can Holder

Wrap your drink up for spooky season with this mummy can holder. The body is covered in raised, overlapping bandage detail, with openings for the eyes and mouth so the can inside peeks through and becomes part of the face.

The two-piece design is the mummy-shaped main holder and a matching bandage-textured lid with an opening for a straw. It is sized for a standard 12 oz beverage can, including soda, sparkling water and similar canned drinks.

What you choose

• Colour – from our full filament range. The photos show it in white, which reads most like real bandages, but any colour in the range is yours to pick.

Details

• Assembled approximately 3.28 in wide x 3.30 in deep x 7.15 in tall (83.29 x 83.70 x 181.50 mm)
• Main holder approximately 3.28 in wide x 3.25 in deep x 5.63 in tall
• Removable lid approximately 3.22 in wide x 3.30 in deep x 1.52 in tall
• Sold as one two-piece mummy can holder set
• Printed in PLA, designed and made by 3D05 in Doral, Florida

Good to know

• The beverage can and straw shown in the photos are for display only and are not included.
• This is an outer sleeve for a canned drink, not a cup. Drinks should not be poured directly into it.
• It is not insulated and will not keep a drink hot or cold the way a vacuum tumbler does.
• Hand wash or wipe clean with cool or lukewarm water and let it air dry. No dishwasher and no microwave, and keep it out of high heat, because PLA softens at raised temperatures.
• Each piece is individually made, so subtle layer lines and small variations between pieces are normal characteristics of the process.
• No personalisation on this item.
• Made to order in 2 to 3 business days, then shipped, or collected free from our Doral workshop.