1 $19.99

Shop /Seasons/Fall

Jack-O'-Lantern Pumpkin Can Holder

A carved pumpkin that hides a 12 oz can, with the face cut through and a stemmed lid with a straw opening. Body colour is yours to pick.

Orange jack-o-lantern drink can cover with green stem lid and a straw

$19.99

Plus tax and shipping. Free pickup in Doral.

Made to order in 2 to 3 business days.

Colour Pick one
The stem always prints dark green. Your colour choice covers the pumpkin body and the lid. Swatches are sampled from our filament photos, so screen colours are close but not exact.

Related products

Made to order 2 to 3 business days
Colour choices 23 filament colours
Material Printed in PLA
Pickup or delivery Free pickup in Doral

About this piece

Bring a classic Halloween look to your canned drink with this jack-o-lantern can holder. The pumpkin body carries a carved-style face, with triangular eyes and nose and a wide smiling mouth, cut clean through the wall so the colour and artwork of the can inside shows through. The lantern changes depending on which drink you put in it.

The matching removable top has a dark green stem and an opening for a straw, finishing the pumpkin while still leaving easy access to the drink. It is sized for a standard 12 oz beverage can, so it suits soda, sparkling water and other canned drinks.

What you choose

  • Colour – the pumpkin body and the lid, from our full filament range. The photos show the classic orange, but any colour in the range is yours to pick.
  • The stem is always dark green. It is printed separately and is not part of the colour choice, so it stays green whichever body colour you go for.

Details

  • Main body approximately 4.29 in wide x 4.27 in deep x 5.63 in tall (108.85 x 108.53 x 143.02 mm)
  • Removable lid approximately 3.37 in wide x 3.26 in deep x 2.44 in tall (85.58 x 82.80 x 61.91 mm), including the stem
  • Approximately 178.1 g (6.28 oz) of PLA in the finished parts, from about 205.8 g (7.26 oz) printed including support material
  • Sold as one two-piece can holder set
  • Printed in PLA with a contrasting dark green stem, designed and made by 3D05 in Doral, Florida

Good to know

  • The beverage can and straw shown in the photos are for display only and are not included.
  • This is an outer sleeve for a canned drink, not a cup. Drinks should not be poured directly into it.
  • It is not insulated and will not keep a drink hot or cold the way a vacuum tumbler does.
  • Hand wash or wipe clean with cool or lukewarm water and let it air dry. No dishwasher and no microwave, and keep it out of high heat, because PLA softens at raised temperatures.
  • Each piece is individually made, so subtle layer lines, small surface variations and minor differences between pieces are normal and make each one slightly unique.
  • No personalisation on this item.
  • Made to order in 2 to 3 business days, then shipped, or collected free from our Doral workshop.