Ghost Can Holder

Give your canned drink a spooky disguise with this ghost can holder. The simple ghost silhouette has two eye openings and an open mouth cut clean through the wall, so the colour and artwork of the can inside shows through. The face changes depending on which drink you put in it.

The two-piece set is the ghost-shaped main holder and a removable rounded lid with a straw opening. It is sized for a standard 12 oz beverage can and works well for soda, sparkling water and similar canned drinks.

What you choose

• Colour – from our full filament range. The photos show the classic white, but any colour in the range is yours to pick.

Details

• Main holder approximately 5.04 in wide x 4.55 in deep x 5.63 in tall (128.03 x 115.67 x 143.01 mm)
• Removable lid approximately 3.54 in wide x 3.27 in deep x 1.66 in tall (89.87 x 83.06 x 42.15 mm)
• Sold as one two-piece ghost can holder set
• Printed in PLA, designed and made by 3D05 in Doral, Florida

Good to know

• The beverage can and straw shown in the photos are for display only and are not included.
• This is an outer sleeve for a canned drink, not a cup. Drinks should not be poured directly into it.
• It is not insulated and will not keep a drink hot or cold the way a vacuum tumbler does.
• Hand wash or wipe clean with cool or lukewarm water and let it air dry. No dishwasher and no microwave, and keep it out of high heat, because PLA softens at raised temperatures.
• Each piece is individually made, so subtle layer lines and minor variations are normal characteristics of the process rather than faults.
• No personalisation on this item.
• Made to order in 2 to 3 business days, then shipped, or collected free from our Doral workshop.